Rapid Prototyping Service

What causes short shot of plastic mold in injection molding?

Short shot refers to the phenomenon that the cavity of plastic mold is not completely filled due to the insufficient fluidity of plastic, resulting in incomplete plastic products. The main reason is improper injection pressure and speed (including excessive pressure loss caused by resistance), which is mainly affected by the following aspects:
 
1、 Injection molding machine
(1) Insufficient injection molding capacity – this is caused by the high capacity of the injection molding machine, which may also be caused by insufficient […]

Customized processing of plastic injection mold for JasonMould automobile

The automobile industry has developed rapidly in the past ten years, and more and more new products have entered the market, such as new energy vehicles. A large number of automatic parts are made of plastic. As a new material of automobile parts, plastic parts can reduce the weight of automobile and save energy, so they are widely used in automobile industry. This means that a large number of plastic injection molds are needed to produce the required plastic […]

The advantages of spray painting on the surface of plastic parts

The surface of the plastic part can be sprayed to ensure the brightness of the product. Because plastic is so hard to embody, plastic parts look darker, and even darker if they are covered in leather. Therefore, in the pursuit of a beautiful surface, Some customers requires to spray a layer of  painting on the surface of plastic parts. This will ensure the brightness of the product.
Spraying the surface of plastic parts can reduce the scrap rate of parts. […]

How to prevent stripe defects in precision injection molding?

As we all know, the stripe defect in mold is a very serious matter, it will directly affect the accuracy of injection molding, and will also lead to product scrap, so we must pay attention to. So, how can we avoid this defect?
Proper design, careful processing, reasonable mold repair and timely nitriding are the key measures to prevent the occurrence of stripe defects in precision injection molding.
It should be processed in strict accordance with the requirements of the drawing, […]

What will be caused when injection mold testing in many times?

The design of the injection mold was not fully collectively reviewed, and the structure of the injection mold was unreasonable, which caused the injection mold to undergo multiple improvements after the test, which made the injection mold cost exceed the budget.
If it can be solved after several improvements, it is relatively fortunate. There are many cases that are unsatisfactory, and even the injection molds have to be scrapped and reworked. This cost cannot be controlled.
There are also cases where […]

Why plastic parts have deformation when processing

In order to ensure the normal processing of plastic parts, operators need to understand the cause of the abnormal appearance in this process, the better to avoid the abnormal appearance during processing. Below, JasonMould share you the causes of deformation in processing:
 
 

During the process of molding, the surplus material is spilled into the gap between the mold and the mold surface and retained on the plastic part. A kind of linear trace on the surface of plastic parts, is […]

How to solve the surface sag in 2K mold

The basic reason for surface sag: from the perspective of plastics, when the plastic cools and shrink, insufficient filling will lead to product surface sag or internal cavity.
 
The causes and solutions of defects are different depending on the location of sag.
 

When the sag occurs at the final cooling position of the thick-walled product, or at a distance from the sprue:

 
Cause analysis: The typical thick wall and the surface sag or hole far from the sprue are usually due to […]