Verfspuitbehandelingsproces van prototypes, Verfspuitbehandelingsproces van prototypes, Verfspuitbehandelingsproces van prototypes, wat niet goed is voor het hechten van olieverf om het gewenste glanseffect te bereiken. De CNC Prototype Machining work-pieces, onder andere gemaakt van PP en POM, niet geschikt om met het oppervlak voor spuiten om te gaan, omdat de materialen geen hechting hebben bij spuiten. Voor het schilderen, it needs to polish with abrasive paper. The abrasive paper is divided into several types, such as raw abrasive paper and fine abrasive paper. It can polish the touching water edge of the work-piece edge, and polish it with the finest abrasive paper for the last time, then it’s time to spray grit and bottom ash. If its surface has been treated with high glossy, it needs to be polished finer, and then spray a layer of priming paint to polish it again.
The physical means, adopted in accordance with the specific conditions of production site and different surface appearances of work-piece with prototype treating, mainly aims at eliminating the control factors that influence the processing quality and cycle in the chemical treatment, as well as aims at maintaining the working life of chemical agents. Bijvoorbeeld: Artificially scrub and remove (mainly adopt wire brush and abrasive cloth) the excessive oil stain, stof, iron filings, piece of rust, floating rust, as well as too thick oxide skin, and products that cannot be acid washed, on the surface of new handled product. Then remove the rust dust with compressed air. It also helps reduce lots of loss of degreasing and rust removing solution, avoid the loss of over-treating work-piece, shorten the chemical treatment cycle, and improve the working life of treating fluid. The pre-treating degreasing should apply the fully diluted degreaser to scrub, and should be strictly prohibited to apply organic solvent (such as gasoline and lacquer thinner), so as to avoid polluting the degreasing bath solution and forming organic solvent solid protective films on its timeliness surface, which will lead to influence the degreasing quality.
Over JasonMould Industrial Company Limited:
JasonMould is een van de beste fabrikant van kunststof spuitgieten die geweldige diensten bieden aan hun klanten als het gaat om het vervaardigen van geavanceerde vormgereedschappen. Ze exporteren hun gereedschap naar verschillende delen van de wereld en zijn een van de bekendste namen in de industriële sector geworden.
Aanvraag Contact::
Contactpersoon: James Yuan
Bedrijfsnaam: JasonMould Industrial Company Limited
Adres: LongGang Village,LongXi Town,BoLuo County,HuiZhou-stad,Provincie GuangDong, China
Telefoon: 86-752-6682869
E-mail: [email protected]
Website: https://www.jasonmolding.com
