Prototipleri bitirdikten sonra herhangi bir sprey boyama işlemine ihtiyaç duyarsa, SLA hızlı prototipleme iş parçasının yüksek parlak yüzey işlemine uymadığını lütfen unutmayın., çünkü ışığa duyarlı reçineyi kullandı, İstenilen parlaklık efektini elde etmek için yağlı boyayı yapıştırmak için iyi olmayan. NS CNC Prototype Machining work-pieces, PP ve POM'dan yapılanlar dahil, sprey boyama için yüzeyle uğraşmaya uygun değil, çünkü malzemelerin sprey boya ile yapışkanlığı yoktur. boyamadan önce, it needs to polish with abrasive paper. The abrasive paper is divided into several types, such as raw abrasive paper and fine abrasive paper. It can polish the touching water edge of the work-piece edge, and polish it with the finest abrasive paper for the last time, then it’s time to spray grit and bottom ash. If its surface has been treated with high glossy, it needs to be polished finer, and then spray a layer of priming paint to polish it again.
The physical means, adopted in accordance with the specific conditions of production site and different surface appearances of work-piece with prototype treating, mainly aims at eliminating the control factors that influence the processing quality and cycle in the chemical treatment, as well as aims at maintaining the working life of chemical agents. Örneğin: Artificially scrub and remove (mainly adopt wire brush and abrasive cloth) the excessive oil stain, toz, iron filings, piece of rust, floating rust, as well as too thick oxide skin, and products that cannot be acid washed, on the surface of new handled product. Then remove the rust dust with compressed air. It also helps reduce lots of loss of degreasing and rust removing solution, avoid the loss of over-treating work-piece, shorten the chemical treatment cycle, and improve the working life of treating fluid. The pre-treating degreasing should apply the fully diluted degreaser to scrub, and should be strictly prohibited to apply organic solvent (such as gasoline and lacquer thinner), so as to avoid polluting the degreasing bath solution and forming organic solvent solid protective films on its timeliness surface, which will lead to influence the degreasing quality.
Tarafından Çin kalıp üreticisi
JasonMould Industrial Company Limited Hakkında:
JasonMould en iyilerinden biridir. plastik enjeksiyon kalıplama üreticisi Gelişmiş kalıplama araçları üretme konusunda müşterilerine harika hizmetler sunan. Aletlerini dünyanın farklı bölgelerine ihraç ederek sanayi sektörünün en ünlü isimlerinden biri haline geldiler..
Soruşturma İletişim:
İlgili kişi: James Yuan
Şirket Adı: JasonMould Sanayi Limited Şirketi
Adres: Uzun Çete Köyü,LongXi Kasabası,BoLuo İlçe,HuiZhou Şehri,Guangdong Eyaleti, Çin
Telefon: 86-752-6682869
e-posta: [email protected]
İnternet sitesi: https://www.jasonmolding.com
